Need help?Do you have a question about the Hunter 80707 and is the answer not in the manual?
Details on permanent motor lubrication and handling noise issues.
Instructions for cleaning the grill and fan assembly components.
Turn off power, loosen screws, and remove motor/blower and packing.
Remove screw tip covers and adjust tips flush with housing.
Instructions for new construction where the unit attaches to a joist.
Instructions for new construction suspended between joists.
Instructions for existing construction accessible from above.
Instructions for existing construction accessible only from below.
Position unit, secure to joist, and install wiring cover plate.
Pull wires, connect ducting, and refer to wiring diagram.
Reinstall motor, ensure wires are not pinched, and secure with screws.
Turn on power source and test the motor operation.
Slide mounting rails, mark screw positions, drill holes, and attach rails.
Insert screws leaving space between head and joist, then tighten.
Install wiring cover plate and connect 4" ducting to vent outside.
Connect wiring from the motor to the wiring cover plate.
Reinstall motor, ensure wires are not pinched, and secure with screws.
Turn on power source and test the motor operation.
Position unit, mark screws, drill holes, and slide mounting rails into brackets.
Adjust screws and attach rails to joists based on sheetrock thickness.
Connect 4" ducting and pull wires through strain relief.
Tighten strain relief screws, install wiring cover, and connect motor.
Reinstall motor ensuring wires are not pinched, then secure with screws.
Turn on power source and test the motor operation.
Move housing into position, pull wires, and attach existing ducting.
Install housing flush with sheetrock, secure with screws, connect wires.
Reinstall motor ensuring wires are not pinched, then secure with screws.
Turn on power source and test the motor operation.
Remove star nuts, align posts, and slide support bar and hiding plate.
Feed mounting cable, attach to bracket, and secure strain relief.
Raise bezel, screw finial, and place glass using retainer rings.
Connect fan motor and light wires according to the diagram.
Solutions for fan not operating: check power, connections, and wiring.
Solutions for light not operating: replace bulb, check power, connections, and wiring.
Solutions for noisy fan: tighten fasteners, check glass and flapper.
Details on limited warranty for parts, labor, and motor for one/five years.
Conditions that void the warranty, exclusions, and liability limitations.
To Next Page
General
