Hunter 80707 - Existing Construction: Accessible Only From Below (Continued); Motor Reinstallation and Securing; Power On and Testing

43053-01 - 09/12/2011
16
D20
D17
D18
D19
D21
D22
Turn on the power source.
Test the motor. If the motor does not run, check the
plug connection.
Secure the motor by tightening the 2 screws.
Install the wiring cover plate.
Reinstall the motor by inserting the tabs and pushing up into
position. Make sure the wires are not pinched between the
motor and the housing.
Connect wiring from the motor to the wiring cover plate.
ON
OFF
D22