Hunter 80707 - Attaching the Grill; Initial Grill Assembly; Wiring Harness and Strain Relief; Bezel and Glass Installation

43053-01 - 09/12/2011
17
E5
E4
E1
E2
E3
[a]
Plug in wiring harness.
Remove the two star nuts.
Insert the strain relief bracket’s dog-leg tab so that it hooks over
the lip of the motor. Reinstall the strain relief bracket screw.
Feed the mounting cable through the hiding plate, then attach
mounting cable [a] to the support bracket.
Align posts B and D (stamped into motor housing) with posts B
and D (stamped into light fixture). Slide support bar and hiding
plate onto posts.
NOTE: The grill’s size, shape, and number of lights may vary.
Raise the bezel onto the threaded rod of the support bracket.
E6
Attaching the grill