Hunter 80707 - New Construction: Attaching to Joist; Housing Installation and Securing; Ducting and Wiring Connections

43053-01 - 09/12/2011
6
New construction attaching to joist
Screw pre-loaded screws into joist or framing.
Go to step F1 on page 20 to connect the wires as shown.
Connect 4” duct and vent to the outside. Tape joints.
If ducting does not fit securely, an adapter may need
to be purchased.
Position the correct depth mark at the bottom edge of
the joist based on the thickness of your sheetrock.
Pull wires through the strain relief.
Install the wiring cover plate. Make sure all wiring connections
are inside the box or under the wiring cover plate.
5/8
1/2
A11
A12
A13
F1
A14
A15
0
A16