Hunter 80707 - New Construction: Attaching to Joist (Continued); Motor Reinstallation and Securing; Power On and Testing

43053-01 - 09/12/2011
7
A20
A21
ON
OFF
0000
A17A17
A17
0000
A18
A19
Reinstall the motor by inserting the tabs and pushing up into
position. Make sure the wires are not pinched between the
motor and the housing.
Turn on the power source.
Go to step E1 on page 18 to attach grill.
Connect wiring from the motor to the wiring cover plate.
Secure the motor by tightening the 2 screws.
Test the motor. If the motor does not run, check the
plug connection.
E1
A22