OPERATION
This appliance is for household use only.
1.
surface where it cannot fall or
be pulled by the cord.
2. Plug the fan into a grounded
120-volt AC electrical outlet
(ordinary household current).
DO NOT use any other type of
outlet. Make sure that the rated
voltage of the fan is the same
as the power source before
plugging it into the power
source.
3. Turn the fan “ON” or “OFF”
by moving the power/speed
lever. The power should always
be OFF before unplugging the
fan.
4. To select the speed, move the
power/speed lever from OFF to
the desired speed setting: O (off),
I (Low), II (Medium), III (High).
5. To control the upward and
loosen the screw on the side of
the fan housing neck. Adjust to
the desired angle and tighten
the screw.
Handle
Oscillation Knob
Motor Housing
Up/Down
Adjustment Screw
Base
Power/Speed
Lever
8
6. To make the fan oscillate, push
knob up. The oscillation knob is
the oscillation knob down. To
located on the top of the fan
stop oscillating, pull the oscillation
housing, near the handle.
Figure 14
61901-01 R20210927
To Next Page
Loading...
