6
Figure 3
This product employs overload protection (fuse). A blown
fuse indicates an overload or short-circuit situation. If the
fuse blows, unplug the product from the outlet. Discard
product if the attachment plug is damaged. To reduce the
remove, replace, repair or tamper with the originally
supplied plug. If the fan does not function properly, it may
be due to the safety device incorporated in this plug.
If the fuse fails, it is generally due to a short circuit or
circuit overload. Replace the fuse as per the instructions
below (follow product marking for proper fuse rating)
and check the product. If the replacement fuse
fails, a short-circuit may be present and
immediately unplug the unit and contact our
technical support department for assistance.
Fuse Replacement:
Grasp plug and remove from the receptacle or other
outlet device. Do not unplug by pulling on cord.
Locate the door on top of the plug. Figure 3.
2. Slide the door on top of the plug towards the blades.
Figure 4.
3. Carefully remove the fuse from the clips holding it on
with 5 Amp, 125 Volt fuse. Figure 5.
Warning! Electrical Hazard! Only replace with a
fuse type and rating matching what was removed from
a safety device (fuse) that should not be removed.
Discard product if the attachment plug is damaged.
the product. If the product fails a second time,
immediately unplug it and contact our technical support
at 1-888-880-3267.
4. Gently push the fuse back into the pins that will hold
it in place.
Note: If the fuse is not seated properly, the unit will not
function.
5.
6. Plug the fan back in and resume use.
FUSED PLUG
Figure 4
Figure 5
Slide the door back over the fuse box in the plug.
61811-01 R20220120
the top and bottom. RISK OF FIRE. Replace fuse only
RISK OF FIRE. Do not replace attachment plug. Contains
To Next Page
Loading...
