Hunter Advocate series - Installing the Remote Control Cradle; Setting up SIMPLEconnect WiFi

9
1886
1886
Installing the Remote Control Cradle
Option 1: Using Adhesive Strip
Option 2: Using Screws
You have two options for installing the remote cradle.
Choose which path works best for you.
Remove the cradle from
the cradle bracket.
Slide the cradle onto
the mounted bracket.
If you are installing into drywall, drill two
9/64 width holes using the cradle bracket
as a guide. Gently hammer the included
drywall anchors into the pre-drilled holes.
Choose your cradle
installation location.
Separate the lining
from the back of the
adhesive strip on
the cradle bracket.
Press the cradle
bracket against the
wall and hold rmly
for 30 seconds.
Ceiling Bracket Downrod Hanging Fan Wiring Canopy Blades Light Remote App
SIMPLEconnect connects to available 2.4 GHZ WiFi networks.
Setting up WiFi
Note: The HomeKit setup code
is located on the front cover of
the English side of this manual.
Launch the app.
Follow the onscreen prompts to set up your fan.
Download the app:
Visit your app store and search “Simpleconnect WiFi” to nd the app.
1
2
3
Need to install the app later?
When ready, turn the wall switch off and then on.
Wait three minutes before downloading the app.
Hunter Pro Tip:
Fan not showing up
in the list? Pull down
to refresh!
Use of the HomeKit logo means that an electronic accessory
has been designed to connect specically to iPod, iPhone, or
iPad, respectively, and has been certied by the developer to
meet Apple performance standards. Apple is not responsible for
the operation of this device or its compliance with safety and
regulatory standards. Please note that the use of this accessory
with iPod, iPhone, or iPad may affect wireless performance.
Compatible with iOS 7.1 or higher / Android 4.3 or higher
Android and Google Play are trademarks of Google Inc.
Apple logo is a trademark of Apple, Inc.
App store is a service mark of Apple, Inc.