Hunter Advocate series - Assembling the Light Kit; Fan Fall Hazard Warning (Light Kit); Installing the Glass; Glass Fall Hazard Warning

8
1886
1886
Ceiling Bracket Downrod Hanging Fan Wiring Canopy Blades Light Remote App
Installing the Glass
ON
Turn Power
Lift the globe and align the
notches in the globe with
the tabs in the light kit.
NOTE: Check to ensure
proper engagement.
Attach the globe by lifting and
turning clockwise one third of a
full turn of the glass until it stops.
Notch
Tab
WARNING
GLASS FALL HAZARD
To prevent SERIOUS INJURY or DEATH, make
sure that glass is properly secured.
Assembling the Light Kit
Align the keyhole slots in the top of the light kit
assembly with the partially installed assembly
screws. Rotate the keyhole slots around the
screws and twist counterclockwise. Tighten all
three screws securely.
Partially install two light kit
assembly screws, found in the
hardware bag, halfway into
the motor housing as shown.
It does not matter which two
screw holes you choose.
WARNING
FAN FALL HAZARD
Make sure all screws are tight to secure
the light xture.
2 of 8
Light Kit Screw
bag
3 of 8
Light Kit Screw
bag
6 of 8
Light Kit Screw
bag
8 of 8
Light Kit Screw
bag
Screw two light kit assembly screws, found in the
hardware bag, through the LED assembly and
into the trim ring.
Raise the LED assembly to the trim ring. Align
the screw holes in the LED assembly with the
screw holes in the trim ring.
Feed the light wires through the hole in the
lower switch housing. Align the lower switch
housing screw holes with the bottom of the
light kit assembly. Using the three light kit
screws, found in the hardware bag, mount
the lower switch housing to the light kit.
Connect the single-pin connectors from the
LED assembly to the connectors from the fan.
Connect the white wires together. Connect the
blue and black wires together. Tuck the excess
wiring above the LED assembly or feed back
into the lower switch housing.