Hunter Astwood - Installing the Canopy; Installing the Blades; Attaching Fan Blades; Assembling the Light Kit

7
8
1886
1886
Assembling the LIght Kit
Partially install two light kit screws, found in
the hardware bag, halfway into the motor
housing as shown. It does not matter which two
screw holes you choose.
2 of 6
Light Kit Screw
bag
1 of 6
Light Kit Screw
bag
Insert the third screw, found in the
hardware bag, in place and rmly tighten
all the three screws.
Ceiling Bracket Downrod Hanging Fan Wiring Canopy Blades Bulbs Cage
Installing the Canopy
x2
Lift the canopy into place so that
the screw holes are aligned.
Insert the two canopy screws
found in the hardware bag.
F
i
t
t
h
e
c
a
n
o
p
y
i
n
p
l
a
c
e
a
s
s
h
o
w
n
.
bag
Canopy Screw
Installing the Blades
Repeat x4
x12
bag
Blade Screw
x12
bag
IMPORTANT
NOTE: Follow the instructions on the blade. Installing it
incorrectly could result in your fan not functioning.
Feed the wire plug through the center hole of the
upper switch housing. Align the keyhole slots in
the upper switch housing with the two screws
you just installed. Lift the upper switch housing so
that the keyhole slots engage the two screws, and
twist counterclockwise to lock the upper switch
housing into place.
Blade Washers
Put the blade washers found in the hardware bag onto the
blade screws found in the hardware bag. Then install the
blade screws to secure each blade to the fan.
WARNING
FAN FALL HAZARD
Make sure screws are tight to secure the upper
switch housing to the mounting plate.