Select “ON”, press “OK”, to set the interval; PIR sensor of
camera will be turned off; camera will shoot pics or video clips
automatically upon the interval user set.
Configurable interval: 5 seconds to 24 hours.
Note! Pls don’t turn ON Time Lapse and Delay simultaneously!
Select “ON”, press “OK”, to set a time interval that you desire
between photos/videos upon motion. This option avoid camera
taking too many photos or videos.
Example: Camera will wait 1 minute between photo/video
recordings with motion if pre-set time interval is 00:01:00
Configurable delay time: 0 second to 24 hours.
Note! Pls don’t turn ON Time Lapse and Delay simultaneously!
Alkaline/ NI-MH
Choose the correct types of batteries for the camera to perform
its best effects.
SD Cycle:
Select “ON”, press “OK”, camera will continue to record
photos/videos by deleting earliest photos or video clips.
Frequency:
50HZ, 60HZ; improper setting may cause camera screen flicker
Select “Yes” to reset camera back to factory default settings.
Firmware version in camera
Firmware is subject to change without prior notice!
To Next Page
Loading...
