Hunter Bennett Series User Manual

8
1886
Installing the Remote Control Cradle
Option 1: Using Adhesive Strip
Option 2: Using Screws
You have two options for installing the remote cradle.
Choose which path works best for you.
Remove the cradle from
the cradle bracket.
Slide the cradle onto
the mounted bracket.
If you are installing into drywall, drill two
9/64 width holes using the cradle bracket
as a guide. Gently hammer the included
drywall anchors into the pre-drilled holes.
Choose your cradle
installation location.
Separate the lining
from the back of the
adhesive strip on
the cradle bracket.
Press the cradle
bracket against the
wall and hold rmly
for 30 seconds.
Troubleshooting
Fan Doesn’t Work
• Make sure power switch is on.
• Check the circuit breaker to ensure the power is
turned on.
• Make sure the blades spin freely.
• Turn off power from the circuit breaker, then loosen
the canopy and check all the connections according
to the wiring diagram.
Excessive Wobbling
• Make sure the blades are properly installed on the
blade iron posts.
• Turn the power off, support the fan carefully, and
check that the hanger ball is properly seated.
• Use the provided balancing kit and instructions to
balance the fan.
Remote Control of Fan is Erratic
• Make sure the battery is installed correctly.
• Install a fresh battery.
Remote Only Works Close to Fan
• Change battery.
Noisy Operation
• Make sure the blades are properly installed.
• Check to see if any of the blades are cracked. If so,
replace all of the blades.
Multiple Remote Issues
• If you have multiple remotes or multiple remote-
controlled fans installed on the same circuit breaker
and you are experiencing interference or faulty
operation of your remote controls, please go to
www.HunterFan.com/FAQs and click “How do I
properly install multiple remote-controlled fans?” for
information on how to correct this issue.
Cleaning the Fan
Use soft brushes or cloths to prevent scratching.
Cleaning products may damage the nishes.
Hunter Pro Tip:
Ceiling Bracket Hanging Fan Wiring Motor Housing Blades Light Remote Troubleshooting
The remote control is already paired for use. For your convenience, a remote function card is packed in
with your remote.

Hunter Bennett Series Specifications

General

Type	Ceiling Fan
Blade Span	52 inches
Mounting Type	Downrod
Motor Speed	3 speeds
Material	Wood
Warranty	Lifetime