KEEP!
Remove the pre-installed
setscrew so that the downrod
can be inserted.
Hand tighten the downrod (at
least 4-5 full turns) until it stops.
The wires can be cut, but
leave at least 8 inches (20
centimeters) extending from
the top of the downrod.
Downrod (continued)
Tighten the setscrew
with pliers. DO NOT
HAND TIGHTEN.
If the setscrew is not tightened
securely, the fan may fall.
K
E
E
P
!
1.888.830.1326
www.HunterFan.com
8 inches (20 centimeters)
3/8 in.
.95 cm
8 in.
3/8 in.
C
U
T
&
S
T
R
I
P
(not to scale)
3/8 in.
.95 cm
8 in.
20 cm
8
M3543-01 • 11/25/13 • © Hunter Fan Company
To Next Page
Loading...
Need help?
General