Hunter Channing - Assembling the Light Fixture; Installing Bulbs and Glass

7
8
1886
1886
Ceiling Bracket Downrod Hanging Fan Wiring Canopy Blades Light Glass/Bulbs
Canopy Screw
WARNING
GLASS FALL HAZARD
To prevent SERIOUS INJURY or DEATH, make
sure that glass is properly secured.
Installing the Bulbs and Glass
Press the globe, globe keeper,
and nial cap ush against
the metal plate. Screw the
nial onto the threaded rod.
Install the included LED
bulbs into the sockets.
When necessary, replace
with bulbs of same wattage.
Repeat x2
Fan style may vary.
Note:
Repeat x5
Notch
Some components not shown for visual clarity.
Give the xture a gentle,
clockwise turn to ensure the
xture is secure and that the
locking pin has engaged.
IMPORTANT
Push the connector and
excess wire into the hole at
the top of the light xture.
The connector and excess wiring
must be pushed into the light
xture in order to successfully
mount the light xture to the fan.
Pin
Raise the light kit to the bottom of the fan.
Align the notch on the mounting ring on the
top of the light kit with the pin in the mounting
bracket on the bottom of the fan.
HOLD HERE
Assembling the Light
Connect the plugs from the fan and light
xture. Make sure to line up the colored
markings on the connectors.
Remove the cardboard plug
guard before proceeding!
Want to install your fan without a light kit?
Go to www.HunterFan.com/FAQs and click “How do I install my
fan without the light kit?”
Hunter Pro Tip: