Hunter Channing - Remote Control Installation; Installing the Remote Control Cradle

9
10
1886
1886
Installing the Remote Control Cradle
Option 1: Using Adhesive Strip
Option 2: Using Screws
You have two options for installing the remote cradle.
Choose which path works best for you.
Remove the cradle from
the cradle bracket.
Slide the cradle onto
the mounted bracket.
If you are installing into drywall, drill two
9/64 width holes using the cradle bracket
as a guide. Gently hammer the included
drywall anchors into the pre-drilled holes.
Choose your cradle
installation location.
Separate the lining
from the back of the
adhesive strip on
the cradle bracket.
Press the cradle
bracket against the
wall and hold rmly
for 30 seconds.
Preparing the Remote
ON
Turn Power
Battery
Door
To access the battery compartment,
remove the Philips screw and the
battery door. The battery should be
installed with the positive (+) side
up. Replace with a CR2032 battery
when necessary.
Phillips
screw