Hunter Dempsey User Manual

6
1886
1886
Installing the Canopy
2 of 3
Canopy
Screws
bag
1 of 3
Canopy
Screws
bag
Swing the fan up to align the
canopy screw holes with the
mounting holes on the ceiling plate.
Using both hands, push the canopy trim
ring up to the top of the canopy. The canopy
trim ring will snap and lock into place.
Hold the canopy up with the screw holes
aligned. Partially install two canopy screws,
found in the hardware bag, into the
holes opposite the ceiling plate hooks.
Partially install a canopy screw, found
in the hardware bag, between
the ceiling plate hooks. When all the
holes are properly aligned, securely
tighten all three canopy screws.
Note: The slots in the canopy
must remain engaged while
swinging the canopy for
alignment.
Note: Should you need to remove the trim ring,
press rmly on opposite sides of the trim ring. The
tabs will ex out releasing the canopy trim ring.
Place the receiver inside the
canopy. Ensure the wires
remain connected.
WARNING
FAN FALL HAZARD
Make sure screws are tight.
Installing the Blades:
Attach each blade to a blade iron using the blade washers, found in
the hardware bag, and the blade assembly screws, found in the
hardware bag.
Repeat x4
x12
bag
Blade Screw
x12
bag
Blade Washer
Ceiling Plate Hooks
Ceiling Bracket Hanging Fan Wiring Canopy Blades Light Bulbs Remote

Hunter Dempsey Specifications

General

Type	Household blade fan
Placement	Ceiling
Fan diameter	1320.8 mm
On/off switch	Yes
Product color	White
Number of speeds	-
Number of fan blades	4
Power consumption (typical)	61 W
Bulb type	LED
Bulb power	9.8 W
Lamps quantity	1 lamp(s)
Number of bulbs	2 bulb(s)