Hunter Gilrock - Installing the Canopy; Installing the Blades

7
8
1886
1886
Ceiling Bracket Downrod Hanging Fan Wiring Canopy Blades Pull Chain
Installing the Canopy
x2
Lift the canopy into place so that
the screw holes are aligned.
Insert the two canopy screws
found in the
hardware bag.
F
i
t
t
h
e
c
a
n
o
p
y
i
n
p
l
a
c
e
a
s
s
h
o
w
n
.
bag
Canopy
Screw
Installing the Blades:
x12
x12
Repeat x6
bag
bag
Blade Screw
Blade Nut
Lightly attach each blade to a blade arm and blade arm connector as shown using the
blade nuts and grommets, found in the hardware bag, and the blade assembly
screws, found in the bag. Leave the trailing edge hole in the blade assembly open
for the following step.
x12
x6
Grommet
Blade Arm Connector
Assembling the Light
Lightly attach the blade arms to the motor with
the blade arm screws, then securely tighten
after both screws are attached.
Remember the screws that you
kept after removing the shipping
blocks? You need them here.
D
I
S
C
A
R
D
K
E
E
P
!
x8
bag
Repeat x6
Blade Arm Screw
Fan style may vary.
Note:
Fan style may vary.
Note:
IMPORTANT
NOTE: Do not tighten screws until blades are fully assembled.