cases, it may be necessary to cycle power to the controller.
HPC - Installing Decoder Module
The HPC controller is supplied with a base 4-station module. This controller is also
compatible with the EZ Decoder System (EZDS) for hybrid conventional and two-wire
operations. Add a Decoder Module (PC-DM) to enable control for up to 32 total stations.
This system uses the same EZ-1 decoders used with ICC2 and HCC controllers.
PC-DM Decoder Module
Station Modules
EZ Decoder Connections and Programming
EZ Decoder with P/MV
Wiring Chart
Installing the PC-DM Decoder Module
The PC-DM can only be installed in the last two station output slots (similar to PCM-900
and PCM-1600 installation). The PC-DM will not physically fit or operate in any other
station output slot.
IMPORTANT: While adding this module increases the total station count to 32, the first 4
To Next Page
Loading...
