www.HunterFan.com
1.888.830.1326
17
M3556-01 • 06/17/14 • © Hunter Fan Company
Globe
Feed the pull chains from the fan switch
and the light switch down through the
holes in the upper switch housing as
shown. Attach the pull chain pendants
to the light and fan pull chains. The fan
pull chain controls the speed: from high
to off. The light pull chain controls
the light xture: on and off.
Partially install two globe assembly
screws, found in the hardware bag,
halfway into the light kit assembly as
shown. It does not matter which two
screw holes you choose.
Carefully lower the globe into the globe
retainer until it rests in place.
Globe
Assembly
Screws
To Next Page
Loading...
