While continuing to hold the “LOCK RELEASE” button, depress the “LOWER” button until the lift reaches the desired height.
Release both buttons when the lift reaches the desired height.
Depress and hold the “LOWER” button until the mechanical locks engage.
If the lift is being lowered completely, ensure the lift rack is resting fully on the oor before removing the wheel chocks.
Remove all wheel chocks.
Before removing vehicle from lowered lift, verify that the turnplates and runway slip plates are locked in place. Use lock pins
if optional PowerSlide feature is not present.
Carefully drive the vehicle off the runways.
Unlock and Lock Slip Plates with PowerSlide® Slip Plates (Optional)
Controls for the PowerSlide® slip plates are located either near lift controls (-PS models) or on the FIA console (-IS models).
.
Page 12 of 17
To Next Page
