4.Detailed Operation Instructions
4.1.Preparation
Lift Operation Safety Rules
Read and familiarize yourself with these instructions before operating lift.
Do not try to operate an improperly functioning lift.
Do not attempt to use a lift for any purposes other than lifting vehicles.
Properly chock vehicle before operating lift.
Make sure lift is clear of personnel and obstructions before operating. Do not operate a lift with anyone on or under the lift
structure.
Watch lift and vehicle when operating.
Do not operate a lift with anyone in the vehicle.
Always set lift on safety lock latches before working on the vehicle.
Do not operate the vehicle while it is raised on the lift.
Do not operate a lift if the vehicle to be lifted is supported on jacks or any other auxiliary devices.
Do not install or use any unauthorized lifting devices or accessories.
Perform regular maintenance in accordance with instructions in Section Five.
NOTE
It is advisable to use a second person as a “spotter” to give visual assistance to the driver when approaching
and driving onto and off the runways
4.2.Chocking Procedure
Read and thoroughly familiarize yourself with these instructions before operating the lift.
Adjust the turning angle gauges (with lock pins installed) to match the tread width of the vehicle
CAUTION
For safety, proper chocking of vehicle wheels is very important to prevent the vehicle from rolling while
positioned on elevated runways.
1. Drive the vehicle onto the rack, place the transmission in PARK, and SET the emergency brake
2. Place a wheel chock, 22-525-2, at the front and rear of the left rear wheel.
.
Page 9 of 17
To Next Page
