8
Ceiling Bracket Downrod Hanging Fan Wiring Canopy Blades Control
Installing the Switch Housing and Cap
ON
Turn Power
Lift the cap and align cap
holes with the extend tabs
of the fan housing.
Insert the cap screws found in
the hardware bag
Partially install two switch housing screws, found
in the hardware bag, halfway into the motor
housing as shown. It does not matter which two
screw holes you choose.
2 of 3 1 of 3
Switch Housing
Screw
Switch Housing
Screw
bag bag
Align the keyhole slots in the upper switch housing
with the two screws you just installed. Lift the upper
switch housing so that the keyhole slots engage the two
screws, and twist counterclockwise to lock the upper
switch housning into place.
Insert the third screw found in the
hardware bag, into place and then tighten all
three screws.
4 of 4
Cap Screw
bag
Fan style may vary.
Note:
To Next Page
Loading...
