Hunter Lakeway 52582 - Remote Control and Troubleshooting; Remote Preparation and Guide; Common Troubleshooting Issues

9
1886
1886
Ceiling Bracket Downrod Hanging Fan Wiring Canopy Blades Control
Troubleshooting
Cleaning the Fan
Use soft brushes or cloths to prevent scratching.
Cleaning products may damage the nishes.
Hunter Pro Tip:
Fan Doesn’t Work
• Make sure power switch is on.
• Check the circuit breaker to ensure the power is turned on.
• Make sure the blades spin freely.
• Turn off power from the circuit breaker, then loosen the canopy
and check all the connections according to the wiring diagram.
Excessive Wobbling
• Make sure the blades are properly installed on the blade iron
posts.
• Turn the power off, support the fan carefully, and check that the
hanger ball is properly seated.
Noisy Operation
• Make sure the blades are properly installed.
• Check to see if any of the blades are cracked. If so, replace all of
the blades.
Remote Control of Fan is Erratic
• Make sure the battery is installed correctly.
• Install a fresh battery.
Multiple Remote Issues
• If you have multiple remotes or multiple remote-controlled fans
installed on the same circuit breaker and you are experiencing
interference or faulty operation of your remote controls, please
go to
www.HunterFan.com/FAQs and click “How do I properly install
multiple remote-controlled fans?” for information on how to
correct this issue.
Preparing the Remote
Phillips
Head
Screw
Battery
Door
The remote control is
already paired for use. For
your convenience, a remote
function card is packed in
with your remote.
NOTICE
• Always purchase the correct size and grade of
battery most suitable for the intended use.
• Replace all batteries of a set at the same time.
• Clean the battery contacts and also those of the
device prior to battery installation.
• Ensure the batteries are installed correctly with
regard to polarity (+ and -).
• Remove batteries from equipment which is not to
be used for an extended period of time.
• Remove used batteries promptly.
To close the battery
compartment, secure
the battery door to the
transmitter assembly with
the small Phillips head screw.
Replace with a CR2032
battery when necessary. The
battery should be installed
with the positive (+) side up.
Remote Function Guide
Fan On/Off+ Quick Press
Light Dimming+ Long Press
Light On/Off+ Quick Press
Key Press Function
Dimming Mode
On/Off
+
Long Press
MA092-01
Raise Fan
Speed
Lower Fan
Speed
+ Quick Press
+ Quick Press
Fan Reverse+ Long Press
+
Long Press
Fan Updraft
+ Long Press
Fan Downdraft
Light Function
(DOES NOT WORK)
(Does not work)
(Does not work)