USB Connection
When camera is connected via USB cable; screen displays “MSDC”,
press “Menu” once, “MSDC” turns to “PC Cam”, camera can now be
used as a PC camera; press “Menu” again, camera exits PC camera
mode.
Attention!
1. Insert the SD memory card correctly, camera does not support hot
swap (insertion).
2. Use high-quality AA batteries to prevent battery cell corrosion of
leaked acid.
3. Do not invert the battery polarity in the compartment when putting in
the batteries.
4. Use only original adapter (12V/2A) that is adapted for this camera.
Hunter Power Adapter (Article NB: TL20130).
5. In Test mode, camera will automatically power off in 3 mins if there is
no keypad touching.
6. Do not interrupt power supply during firmware upgrade, contact your
local dealer for assistance if the device does not work after upgrading.
7. Do not frequently insert or pull-out SD card and battery or plug in and
out the adapter when the camera is ON.
8. Do not have any floating objects, such as leaves, strings, or ribbons in
the 3M motion detection zone of camera, to avoid accidentally taking
photos or videos.
9. Do not keep the camera next to hot irrelevant objects, air conditioner
exhaust vents, and light, etc..., to avoid accidentally taking photos or
videos.
10. The camera is equipped with 58° FOV lens and 60pcs IR LEDs. To
ensure IR LEDs can give enough flash in dark environments, use high
quality AA batteries that delivers enough amperage to power the
illuminator.
To Next Page
Loading...