9
Ceiling Bracket Hanging Fan Wiring Installing Fan Body Blades Light Remote App
Preparing the Wall Control
Ensure the power 
is OFF at the outlet 
box and wall switch 
location before 
proceeding with 
installation.
Turn Power
OFF
1
Turning off the power
2
Installing the battery
To access the battery 
compartment, slide the battery 
door up. 
Replace the used battery with 
two AAA batteries when needed.
3
Wiring the Wall Control
Connect the grounding wire 
from the wall control to the 
ground control from the switch 
box using the provided wire 
nuts.
Connect the “LIVE IN” from 
the switch box to the “~VAC” 
from the wall control using the 
provided wire nuts.
Connect the “LIVE OUT” from 
the switch box to the “FAN” out 
from the wall control using the 
provided wire nuts.
Push all wires into the switch 
box.
4
Installing the Wall Control
Install the longer screws 
through the slots in the wall 
control into the switch box 
screw holes.
Use the pull-chain 
switch on the fan to set 
the fan speed to the 
HIGH position before 
operation.
Turning on the power
ON
Turn Power
IMPORTANT
6
5
Installing the Wall Plate
Install the shorter screws 
through the wall control 
plate and into the screw 
holes in the wall control.
The remote transmitter is already paired to 
the receiver and ready to use. If you need 
to pair your remote, cycle power to the fan 
by turning power off and back on at the 
wall switch (or circuit breaker if necessary). 
Within three minutes, do the following:
Reference the included remote function card for 
information on how to use your wall control!
7
8
This device complies with Part 15 of the FCC 
Rules. Operation is subject to the following 
conditions: (1) this device may not cause harmful 
interference, and (2) this device must accept any 
interference received, including interference that 
may cause undesired operation.
KEY PRESS
FUNCTION
LIGHT FUNCTIONS
FAN FUNCTIONS
KEY PRESS
FUNCTION
Remote Function Guide
Fan On/Off
Light Dimming
Control
Dimming Mode 
On/Off
+ 
Light On/Off
Light High
Fan High
Light Low
Fan Low
Fan Reverse
Power On/Off
Long 
Press
Long 
Press
Long 
Press
Long 
Press
Long 
Press
Long 
Press
Fan Speed 
Control
Key Press Function
Remote Function Guide
Fan On/Off
Light Dimming
Control
Dimming Mode 
On/Off
+ 
Light On/Off
Light High
Fan High
Light Low
Fan Low
Fan Reverse
Power On/Off
Long 
Press
Long 
Press
Long 
Press
Long 
Press
Long 
Press
Long 
Press
Fan Speed 
Control
Key Press Function
Battery 
Door