Getting Started 7
A manufacturer’s identification label is on the rear of the
balancer.
Figure 7: Manufacturer ID label
Specific Precautions/Power Source
The Road Force
®
Elite GSP9700 Balancer is intended to
operate from a power source that will apply 230VAC
+10% / -15%, 1 phase, 10 amp 50/60 Hz, power.
The power cable includes a NEMA 20 amp plug, L6-20P,
between the supply conductors of the power cord and uti-
lizes a twist lock connector.
Figure 8: : NEMA L6-20P Plug
Optical Scan Laser Precaution
The Optical Scan Laser is a class 1 laser designed to
measure the profile of wheel assemblies. The laser is not
a field serviceable part. No maintenance is to be per-
formed on the laser.)
Figure 9: Class 1 Laser Warning
Wavelength: 650nm.
HammerHead
®
TDC Laser Precaution
The TDC (Top Dead Center) Laser Indicator is a class
2M laser designed to aid in applying clip-on weights. This
is an option feature that is not a field serviceable. Laser
Radiation - Do not stare into the beam or view directly
with optical instruments.
Figure 10: Class 2m Laser warning
Turning Power ON/OFF
Push Button Switch.
Balance is equipped with a push button power switch
located on the left side of the LCD support. Use this
switch for normal shut down and restarting procedures.
Figure 11: push button power
A protective ground connection is essential for
safe operation.
Always use the push button switch on the LCD
support to power the balancer on/off to prevent
data loss
To Next Page
Loading...
