Insert / replace batteries
The computer requires 4 x 1.5V batteries of size AA (mignon). Insert them into the battery compartment on the back of
the computer. If the display is weak or has dropouts, replace all batteries.
Using a chest-belt
The computer is equipped with a built-in receiver for the wireless receipt of the pulse freqeuncy with a compatible
chest-belt (frequency: 5.3 kHz, not included in the scope of delivery). Recommended range: 100 - 150 cm.
If you want to transmit your pulse frequency via chest-belt, follow these instructions:
1.
Make sure, the correct battery is inserted into the chest belt (button cell of type CR-2032, 3 volts). Battery
replacement: Open the battery case cover on the back side of your transmitter (you may use a coin for easier
sealing ring ist correctly placed. Close the case cover properly.
2.
The transmitter needs to be attached to the belt with the 2 buttons. Moisten the electrodes slightly before wearing
the belt. This increases the contact sensibility and enables a better wireless signal transmitting.
3.
Put on the chest belt and make sure the electrodes are touching your breast directly. You may adjust the belt to a
comfortable length. However, the electrodes must have contact with your skin in order to measure your heart rate
correctly.
4.
The 5.3 kHz-chest-belt communicates with the computer via the built-in receiver. It may last up to one minute
before a correct display can be seen.
Safety hint:
Do not use the chest-belt if you have a pacemaker, unless you double-checked with the producer of the pacemaker
and with your doctor!
Battery-Disposal:
Batteries should not be considered as regular garbage. As consumer you are obliged to return finished batteries. The
finished batteries can be returned to a collection base at your residential area or at places, where batteries can be
bought.
The computer can be connected via Bluetooth® to communicate with the apps Fitshow..
Fitshow
Turn on Bluetooth® on your mobile device, download the app and install it on your iOS or Android device. You can
mobile device.
To record training data, you need to register in the app. However, a simple training without permanent data recording
is also possible without registration.
To start a workout with the app, you must first activate the Bluetooth® function of the device computer (press the
- the Bluetooth® icon appears on the display.
To Next Page
Loading...