19
45019-01 • 06/03/11 • Hunter Fan Company
9 • Completing Your Installation With or Without a Bowl Light Fixture (Continued)
Steps 9-9 – 9-12
Step 9-12
Switch
Housing
Cap
Plug Button
Uninstalling the Light Fixture
9-9. Remove the lower switch housing screws, then
remove the lower switch housing.
9-10. Disconnect the male / female terminals on both white
and black wires.
9-11. Remove the wire connectors on both the white and
black wires.
9-12. Remove the nut and washer from inside the lower
switch housing. Separate the light xture from the
lower switch housing.
9-13. Use the dummy terminals (included) to cover the
ends of the black and white wires in the lower switch
housing. e black wire receives the female dummy
terminal, and the white wire receives the male dummy
terminal.
9-14. Install the switch housing cap and plug button to the
lower switch housing.
9-15. Store the light xture, nut, washer, and lead wires for
possible future use.
Nut
Washer
Female
Dummy
Terminal
Male
Dummy
Terminal
Step 9-13
Lower Switch
Housing
Lower
Switch
Housing
Screw
readed
Rod
Male / Female
Terminals
(shown
disconnected)
Wire
Connector
Lead
Wire
To Next Page
Loading...
