Hurco TM10 User Manual

Lathe Programming Guide
I. Getting Started.
Steps to make sure your lathe is configured properly.
II. Two Axis Lathe Samples
Machines Covered
TM6, TM8, TM10, TM12, TM18
TMX8, TMX10
III. Live Tool Lathe Samples
Machines Covered
TMM8, TMM10
IV. Live Tool Y Axis Lathe Samples
Machines Covered
TMX8MY, TMX8MYS, TMX10MY, TMX10MYS
All live tool lathes that are an “i” series machine will use the same examples.
All examples are done programming in software version 09.02.68
Please read this document until a stop for your machine type is reached.
This document was designed to be used as a work book, do not jump ahead!
This document was developed by Hurco Applications in Indianapolis Indiana by Hurco USA.
THIS DOCUMENT IS STILL IN THE TESTING, THIS DOCUMENT MAY NOT BE EXACT OR COMPLETE AT THIS
TIME, PLEASE CALL HURCO APPLICATIONS FOR ADDITIONAL SUPPORT.

Hurco TM10 Specifications

General

X-Axis Travel	7.9 in
Z-Axis Travel	22 in
Turret Type	12-Station BOT
Spindle Motor Power	20 hp
Tool Shank Size	1" (25 mm)
Max. Turning Diameter	22.05" (560 mm)
Max Turning Diameter	22.05" (560 mm)
Machine Weight	8818 lbs (4000 kg)

Summary

Live Tool Examples

Live Tool Modes and Axis Maps

Overview of live tool modes (M130/M131) and axis maps (G101, G102, G109) for milling operations.

G101/G102/G109 Axis Map Usage

Detailed explanation of axis map functionalities for milling and turning operations.

Milling with Linear Y Axis (G103)

Programming milling operations utilizing the Y-axis with the G103 axis map.

Sub Spindle Machine Operations

Part Transfer Setup and Offsets

Configuring work offsets and parameters for sub-spindle part transfer.

Programming Part Transfer Sequence

Step-by-step programming for transferring parts between spindles.

Cutoff with Bar Stock

Implementing cutoff procedures for bar stock using sub-spindle functionality.

Sub Spindle Turning Procedures