III. Live Tool Examples
Tools
6. Live Drill .201
7. End mill .25
8. End mill .25
When dealing with Live Tool machines there must be an
understanding of these simple codes and how to utilize them.
First off there are two machine modes, milling and turning.
M130 – Turning mode
M131 – Milling Mode
All these codes establish are what spindle will be turning,
as well as which spindle will everything be calculated from;
such as Feed Per Revolution. Turning mode is main spindle (or
sub on MYS machines). Milling mode is Live tools.
There are also 3 axis Maps that apply to the TMM
machines.
G101 – Milling on the face of the part
G102 – Milling on the diameter of the part
G109 – Turning or positional drilling using the c axis
When Using a Milling Map C axis positions cannot be used! Those maps do not
contain a C axis, everything is interpolated from X and Y coordinates.
To Next Page
Loading...
