Hurco TM6 - Milling with G103

Milling with the Linear Y G103 Axis Map
First step is to call the tool
On all Y axis lathes the tool change block will be different from
the two axis and live tool machine.
Since we are adding another axis an offset for the axis must be
able to be applied in case live tools are shifted, or gang tool
holders are used.
G103 (ALLOWS THE Y AXIS TO BE USED)
T0707 (CALLS UP THE TOOL AND APPLIES OFFSET)
Y0. (SHIFTS THE TOOL SO THAT THE TIP IS AT THE CENTER OF ROTATIONS)
G109 (RETURNS TO TURNING AXIS MAP)
Now the tool has been correctly positioned we are ready to
turn the live tool spindle on and start an approach.
G103
G7
M131
G97 M33 S1500
G54
G94
G0 C0.
Z.25
X.625
From here a square profile will be milled with the y axis
Y.625
G01 Z-.875 F50.
Y-.625 F10.
X-.625
Y.625
X.625
G0 Z.25