Hurco TM8 - Grooving Operations

There is no canned cycle for grooving; everything must be
programmed point to point.
X1.1 Z-.3
G96
G1 X.865 F.005
G0 X1.1
Z-.25
G1 X1. F.002
Z-.275
G3 X.95 Z-.3 R.025
G1 X.865
G0 X1.1
Z-.35
G1 X1. F.002
Z-.325
G2 X.95 Z-.3 R.025
G1 X.865
G0 X2.25
M5 (STOP SPINDLE) (DO NOT USE THIS LINE IF THE MACHINE IS A 2 AXIS LATHE. A SPINDLE STOP
IS ONLY NEEDED IF ANOTHER TOOL WERE TO BE CALLED.)
If the machine has live tool capabilities please skip cutoff block
Live tool operations will be programmed before cutoff.