This map can use a G25 Q0. If programming around the
center is desired, or programmed where Z0. is the diameter of
the bar.
To begin a tool must be called and positioned
G103 (ALLOWS THE Y AXIS TO BE USED)
T0606 (CALLS UP THE TOOL AND APPLIES OFFSET)
Y0. (SHIFTS THE TOOL SO THAT THE TIP IS AT THE CENTER OF ROTATIONS)
G109 (RETURNS TO TURNING AXIS MAP)
G104
G7
G25 Q0.
M131
G97 M33 S1500
G54
G94
G0 C0.
X-.75
Z1.25
From here a pocket can be programmed
Y.5
G01 Z.5
Y-.5
G0 Z1.25
G109
M130
G95
G8
M35
G28 U0. W0.
To Next Page
Loading...
