10
9. How to Disassemble and Clean
※ After the product stops operating completely,
pull the power cord plug with dry hands. Even
after the product is stopped, the motor will slowly
come to a stop so wait about 3 seconds before
detaching the chamber set.
01 Detach the chamber set from the product body.
Turn the hopper to open it and then sequentially pull
each of the parts to disassemble them.
02 Wash the parts with a cleaning brush under
running water.
03 Open the discharge cover and juice cap to clean
the chamber.
04 Wipe the product body with a damp towel or soft
cloth.
05 Detach and wash silicone packings after use.
- Residue may still be stuck.
(hopper packing, juice cap packing, extraction
packing, seal packing, chamber packing)
06 You can sterilize the parts by soaking them in
warm water diluted with baking soda, citric acid or
vinegar.
※ Failure to clean the product immediately after use
may cause its stainless steel parts and other parts
to corrode or become discolored due to salt and pulp
from the ingredients. Also, contaminants may be
dried up and stuck inside, which makes it difficult to
disassemble and clean them and may also cause
performance impairment. Be sure to clean and air-
dry it completely immediately after use and store it in
a clean place. For long-term storage, use a cleaning
brush to wash it. Do not clean with boiling or high-
temperature water or use a cleansing sponge, steel
sponge, abrasives and other sharp cleaning tools. Do
not place it in a dishwasher or dish dryer.
To Next Page
Loading...
Need help?
General
