18
How to Clean
※ When you clean the chamber set, wash the
residue inside of the chamber rst. And then
disassemble the chamber packing and wash it
under running water.
If the unit is not cleaned immediately after use, a residue may dry and stick to the unit.
This will make disassembling and cleaning difficult as well as lead to performance
degradation. Do not wash with hot or boiling water, an iron scrubber, abrasive material,
sink solvents, or sharp cleaning tools. Do not put it in a dishwasher or dish dryer. After
washing, thoroughly and naturally dry, and store in a clean area.
NOTE
Clean the parts
Unplug the power cord with dry hands after
the unit has been completely stopped.
Remove the chamber set from the main body.
Twist the chamber cover to open and lift up the
parts in order to disassemble the unit.
Use a cleaning brush and wash the chamber
set under running water.
Open the control lever [OPEN ◯] and juice cap
to wash the chamber.
Wipe the main body with a damp towel or a soft
cloth.
The silicone packing can be disassembled and
washed. (Including juice cap packing, Mid gear
packing, silicone brush)
You can sterilize and clean the product by
soaking it in water with diluted baking soda,
citric acid or vinegar for about 30 minutes.
01
02
03
04
05
06
07
To Next Page
Loading...
Need help?
General
