08 09
How to use
*Do not press the ingredients with anything
except the pusher provided. Please put the
ingredients as 3~4cm sizes.
*When you use the icecream strainer, the juice
can be out through outlet and it is normal
operaon.
*When you extract over 300ml at once, please
open the control lever every 300ml to emit the
pulp.
*For your safety, this unit only works when it’s
correctly assembled with the chamber set.
Put ingredients gradually in the hopper
chute and press with the pusher.
Press [ON] buon to start.
After extraction is completed, place the
switch in stop position to stop.
2
3
1
When using [ON] or [REV] buon, make sure that the
auger stops completely.
누름
정지상태
Stop
[ON]
On
[REV]
Reverse
[ON]
On
[REV]
Reverse
Press
Disassemble and cleaning
1.
2.
If the unit is not cleaned immediately after use, a residue
may dry and stick to the unit. This will make disassembling
and cleaning difficult as well as lead to performance
degradation.
Do not wash with hot or boiling water, an iron scrubber,
abra sive material, sink solvents, or sharp cleaning tools.
Do not put it in a dishwasher or dish dryer. After washing,
thoroughly and naturally dry, and store in a clean area.
NOTE
1.
2.
3.
4.
5.
6.
Unplug the power cord with dry hands after the unit
has been completely stopped.
Remove the chamber set from the main body.
Twist the chamber cover to open and lift up the parts
in order to disassemble the unit.
Use a cleaning brush and wash the chamber set
under running water.
Wipe the main body with a damp towel or a soft
cloth.
The silicone packing can be disassembled and
washed. (Including juice cap packing, chamber
packing, silicone brush)
Soak in water diluted with one or two drops of
baking soda or natural bleach for dishes for about 30
minutes to sterilize and clean.
Cleaning for parts
Open the juice cap, hold the chamber and juice
cap with one hand, and remove the juice cap pack-
ing with your other hand to disassemble.
Please be careful not to drop or damage the juice
cap and chamber when disassembling the unit.
Grab the chamber packing in the chamber sha
with both hands, and li up to remove.
Idenfy the upper and lower part of the chamber
packing and assemble.
(Refer to image)
Juice Cap Packing Chamber Packing