HUROM HP Series User Manual

12 13
3. The Appliance does not work.
Make sure that the power cord is properly plugged in.
Check if the hopper is assembled properly.
If the hopper has not been locked into place, the appliance will not operate for safety reasons.
Check if the appliance is assembled according to the direcons in the manual.
Refer to instrucons for assembly in the manual or consult with your Customer Service Center for
addional assistance.
4. The appliance stops during normal operaon.
Have you in heavy loads or large pieces of ingredients into the appliance?
Refer to page 11 of the manual and follow the guideline for using [REV] buon.
If the issue is not resolved aer following the above process, please contact your local Customer
Service Center.
5. There are ne lines or scratch marks around the squeezing screw.
These are molding marks resulng from the normal manufacturing process.
This is a normal product and there is no problem for use.
1. The main body itself will not work.
For your safety, this unit only works when it’s
correctly assembled with the chamber set.
2. Please assemble according to the safety
sensor.
For your safety, this unit only works when it's
correctly assembled.
8. Juice leaks over the body.
Have you inserted a lot of ingredients into the hopper chute?
If you insert a large amount of ingredients compared to the pulp outlet, the packing is slightly pushed
away, so the juice leaks out of the gap. Do not put too much ingredients by force and just put gradually
for extracon.
9. The hopper does not open.
There might be a lot of residues inside.
Put the lever in half-closed posion, and press [ON] buon to release residues. Press [REV] buon for
3~5 seconds and stop it. Repeat this process 2~3mes.
Have you placed any foreign substances or solid objects (hard seed such as persimmon seed) in
the juicer?
Press [REV] buon and push the ingredients back up toward the hopper chute.
Do not aempt to open by force. Please contact your local Customer Service Center for assistance.
10. The Chamber shakes when squeezing.
Slight shaking may be caused by the motor.
Depending on the texture of the ingredient, there may be slight to more pronounced shaking of
This is a normal phenomenon as auger rotates and it is not a malfuncon. Hard ingredients
(e.g carrot, potato, radish, beet, etc.) may cause more shaking than so ingredients.
7. Do not use in ways other than pressing
on the pusher in the inlet.
It may cause damage, injury, etc.
6. Do not insert too many ingredients at
once.
If you insert an excessive amount of ingredients
or thick ingredients, the unit may stop.
Please check the details below before contacting Technical
Support for repair.
If you need addional informaon, please contact your local Customer Service Center or visit www.hurom.com.
When applying for aer-sales service, please have the manufacturer’s serial number or bar code available.

HUROM HP Series Specifications

General

Brand	HUROM
Model	HP Series
Category	Juicer
Language	English