CLEANING 1 MAINTENANCE INSTRUCTIONS
Follow these instructions to correctly and safely care for your fan
ATTENTION
1 Always unplug the fan before cleaning or disassembling
2. Do not allow water to drip on or enter into fan housing.
3. Be sure to use a soft cloth moistened with a mild soap solution
4. Do not use any of the following as a cleaner: Gasoline, thinner, or benzene
FAN BLADE & FRONT GRILL CLEANING
1. Use a screwdriver to remove the screw at the front grill.
2. Remove the front grill.
3 Clean the fan blade, grill, with a soft damp cloth. DO NOT ATTEMPT TO REMOVE THE
FAN BLADE. Please use caution around the motor housing area. Do not allow the motor
or other electrical components to be exposed to water.
4. Replace front grill and secure with the screw removed in the first step
REPLACEABLE FUSE
The plug is a safety feature, it contains a safety device (fuse), if your replaceable fuse
(5 Amp, 125 Volt) blows, please follow below instructions to replace the fuse.
1
Unplug your fan, grasp plug and remove from the receptacle or other outlet device. Do not
unplug by pulling on cord.
2
Slide open the fuse cover at the side of the plug by using your thumb or a flat screwdriver.
Remove the fuse carefully (Fig.3)
3
4. Put in a new 5 Amp 125 Volt fuse, make sure it is secured in place.
5. Slide back the fuse cover completely.
6. Risk of fire. Do not replace attached plug. Contains a safety device (fuse) that should not
be removed. Discard product if the attached plug is damaged
Fuse cover
Fuse 5 Amp
Fig.3
4
Sliding
open
cover
To Next Page
Loading...
