7
en
es
fr
pt
Do not carry out any changes (additions or conversions) to the
device without obtaining the prior approval of HURST�
All safety instructions on the device must always be complete and
in a legible condition�
Any mode of operation which compromises the safety and stability
of the device is forbidden!
Safety devices must never be disabled!
Before switching on/starting up the device and during operation,
make sure that nobody will be endangered by this�
Repairs may only be performed by a trained service technician�
Only genuine HURST accessories and spare parts may be used�
Please note that when working with the equipment, material could
fall down or suddenly break free as a result of shearing, tearing or
breaking�
Observe all intervals for recurring tests and inspections as de- as de-
scribed in the chapter "Maintenance and care"�scribed in the chapter "Maintenance and care"�
The eDRAULIC devices and batteries are suitable for underwater The eDRAULIC devices and batteries are suitable for underwater
use to a depth of 3m and a duration of 60 minutes� The special use to a depth of 3m and a duration of 60 minutes� The special
battery for salt water operation must be used in salt and sea water�battery for salt water operation must be used in salt and sea water�
Swallowing or inhaling the hydraulic uids can be detrimental to
health� Avoid direct skin contact� Please note that handling hydrau-
lic uid can negatively aect biological systems.
Moving safety bolts, e�g� for removeable tips, must always be fully
inserted and locked�
When using chain sets, make sure that the chains are attached in a
straight line and that there are no knots in the chain�
When working near live components, high voltage ashovers and
the passage of current to the device are to be avoided�
Prevent the electrostatic charging of the device�
HURST eDRAULIC devices are not explosion-protected! Use in
explosion-protected areas is forbidden�
To Next Page
Loading...
