EasyManuals Logo

HUSABERG FS 450 User Manual

HUSABERG FS 450
116 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #9 background imageLoading...
Page #9 background image
GENERAL INFORMATION
A
4
CHECKING THE OIL LEVEL IN THE
HYDRAULIC CLUTCH
Remove the cover to check the oil level in the master
cylinder of the clutch. Remove the screws (1) and lift off
the cover together with the rubber boot (2). The oil level
should be 4 mm below the upper edge when the master
cylinder is in a horizontal position. If necessary, add SAE
10 biodegradable hydraulic oil (e.g.: Motorex clutch fluid
75).
CAUTION: only fill SAE 10 biodegradable
hydraulic oil into the master cylinder. Do not
add brake fluid.
BLEEDING THE CLUTCH
To bleed, remove the cover on the master cylinder of the
clutch. Remove the screws (1) and lift off the cover
together with the rubber boot (2). Remove the vent
nipple from the slave cylinder of the clutch. Mount the
bleeder syringe (3) filled with SAE 10 biodegradable
hydraulic oil (e.g.: Motorex clutch fluid 75).
Continue to add oil until the oil runs out of the hole (A) in
the master cylinder without bubbles. Make sure the oil
does not overflow.
CAUTION: after bleeding the clutch, check the
oil level in the master cylinder. Only fill SAE 10
biodegradable hydraulic oil (e.g.: Motorex
clutch fluid 75) into the master cylinder. Do not
use brake fluid or mix with mineral hydraulic oil.
1
2
3
A

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HUSABERG FS 450 and is the answer not in the manual?

HUSABERG FS 450 Specifications

General IconGeneral
BrandHUSABERG
ModelFS 450
CategoryEngine
LanguageEnglish

Related product manuals