Page 10
OPERATOR INSTRUCTIONS AND PARTS
MC43ETSC & MC43TSC Cultivator
800-345-6007
FOR MODEL MC43ETSC ELECTRIC START
CHARGING THE BATTERY
To charge the battery, check that the battery wiring is
properly connected and plug the battery charger (4681)
into the side of the battery box (4656) with matching
three-prong plug. Plug the other end of the battery
charger into a standard 120V outlet receptacle. Battery
is fully charged when the LED light turns GREEN
on the external charger. The electric start cultivator
(MC43ETSC) will maintain a charge in the battery when
the engine is running.
Batteries may take as long as 8 hours to fully charge
depending on the original charge level of the battery.
NOTE: For long term storage protection, be sure that
the battery is fully charged and the white plastic battery
connector is disconnected. Place the battery box cover
onto the battery box and store in a dry place out of
direct sunlight.
NOTE: Rechargeable batteries have a limited number
of charge cycles and may eventually need to be
replaced. Battery life and number of charge cycles
vary by use.
WARNING
AVOID ELECTRICAL SHOCK! DO NOT USE BATTERY
CHARGER AROUND WATER OR IN WET CONDITIONS.
IMPORTANT
DO NOT SPRAY WATER ON OR NEAR THE ELECTRONICS
OF THE CULTIVATOR AS THIS MAY RESULT IN DAMAGE
TO THE ELECTRICAL COMPONENTS.
DO NOT TRY TO START ENGINE WHILE THE BATTERY
CHARGER IS CONNECTED. THIS COULD DAMAGE THE
ENGINE AND BATTERY.
To Next Page
Loading...
Need help?
General
