T
Tommy JohnsonJul 30, 2025
What to do if Husky 82022 manual reset circuit breaker is open?
- JJoseph MartinJul 30, 2025
If the manual reset circuit breaker on your Husky Jacks is open, reset the breaker by pressing the button on the breaker.
To Next PageTo Next PageWhat to do if Husky 82022 manual reset circuit breaker is open?
If the manual reset circuit breaker on your Husky Jacks is open, reset the breaker by pressing the button on the breaker.
What to do if Husky 82022 Jacks internal circuit breaker is open?
If the internal circuit breaker on your Husky Jacks is open, wait 15 seconds for the breaker to close.
What to do if my Husky 82022 Jacks have no or low voltage?
If your Husky Jacks have no or low voltage, check the battery and electrical connections. Ensure the power supplied is at least 10 Volt DC. If the battery is low, plug the trailer cable into the tow vehicle and start the tow vehicle to provide power to the jack.
How to fix a Husky 82022 Jacks crank handle that won't turn?
If the crank handle on your Husky Jacks won't turn, the brake may be engaged. Disengage the brake by installing the brake release handle on the brake lever and pulling forward.
Install circuit breaker, connect jack wire to "Load", and "Line" to battery positive.
Extend or retract jack using UP/DOWN switch or remote control.
Instructions for using the manual crank handle in case of power failure.
Turn remote ON, use UP/DOWN buttons to control jack, turn OFF when not in use.
Lists common causes and solutions for circuit breaker trips, poor ground, and low voltage.
General
