See www.huskytow.com for Warranty Information / Tech Support / Product Updates.
©2023 Keystone Automotive Operations Inc. All Rights Reserved. September 2023. REV1 Page 5 of 7
REPLACEMENT PARTS
Due to the design of the Husky
®
Super Brute’s
low-friction ball screw, the inner assembly of the jack
does not require regular lubrication. But to keep your
jack in good, functional condition, fully extend the jack
and clean the inner jack tube once per year. After
cleaning, coat the tube with a light grease or silicone
spray lubricant.
REF.
DESCRIPTION PART#
A
MANUAL CRANK
(INCLUDES BRAKE RELEASE HANDLE)
87639
B ADJUSTABLE LEG WITH FOOT PAD 87461
C 30 AMP MANUAL RESET CIRCUIT BREAKER 87526
D 3/8” SAFETY LOCK PIN 32335
E UNIVERSAL CONNECTOR STORAGE KIT 81497
MAINTENANCE
TROUBLESHOOTING
CAUSE SOLUTION
Open Internal
Circuit Breaker
Wait 15 seconds for breaker to close.
Open Manual
Reset Circuit
Breaker
Reset the breaker by pressing the button on
the breaker.
Poor Ground
Check the connection between the negative
terminal on the battery and the vehicle, since
the jack is grounded to the vehicle chassis
through the star washers on the coupler.
Ensure the mounting hardware (bolts,
washers, and star washers) are in good
condition.
No or Low
Voltage
Check battery & electrical connections.
Power supplied must be at least 10 Volt DC.
If the battery is low, plug the trailer cable
into the tow vehicle, and start the tow vehicle
to provide power to the jack.
E
Figure 4
A
B
C
D
CAUSE SOLUTION
Engaged Brake
Disengage the brake by installing the brake
release handle on the brake lever and pulling
forward.
PROBLEM: Crank handle will not turn during manual operation
To Next Page
Loading...
