20
Symbols
Some of the following symbols may be used on this tool. Please study them and learn their meaning. Proper interpretation of these symbols
will allow you to operate the tool better and safer.
Symbol Name Designation/Explanation
V Volts Voltage
A Amperes Current
Hz Hertz Frequency (cycles per second)
~ Alternating Current Type of current
Class II Construction Double-insulated construction
Wet Conditions Alert Do not expose to rain or use in damp locations.
Read The Operator’s
Manual
To reduce the risk of injury, the user must read and understand the
operator’s manual before using this product.
Eye Protection Always wear safety goggles, safety glasses with side shields, or a full face
shield when operating this product.
Safety Alert Precautions that involve your safety.
Risk of Bursting Do not adjust the regulator to result in output pressure greater than the
marked maximum pressure of the attachment. Do not use at a pressure
greater than 155 PSI.
Risk of Fire or Explosion Do not spray flammable liquid in a confined area. The spray area must be
well ventilated. Do not smoke while spraying or spray where a spark or
flame is present. Keep the compressor as far from the spraying area as
possible, at least 15 feet from the spraying area and all explosive vapors.
Risk of Electrical Shock Hazardous Voltage: Disconnect from the power source before servicing. The
compressor must be grounded.
Hot Surface To reduce the risk of injury or damage, avoid contact with any hot surface.
Risk to Hearing Always wear ear protection when using this tool. Failure to do so may result
in hearing loss.
Risk to Breathing Air obtained directly from the air compressor should never be used to supply
air for human consumption.
Drain Tank Drain the tank every day to prevent corrosion and possible injury due to tank
damage. Risk of bursting. Tilt tank to drain.
To Next Page
Loading...
