Husky H1504ST2 - Breaking in the Pump

11 HUSKYTOOLS.COM
Contact 1-888-43-HUSKY for further assistance.
Assembly (continued)
4
Breaking in the pump
□ Check and tighten all bolts, fittings, etc.
□ Turn the pressure regulator knob (G) fully clockwise to
open the air flow.
□ Place the ON/OFF switch (B) in the OFF position and plug
in the power cord.
□ Open the drain valves (K) completely.
□ Place the ON/OFF switch (B) in the ON position and run the
air compressor for 10 minutes to break in pump parts.
□ Place the ON/OFF switch (B) in the OFF position.
□ Close the drain valves (K).
K
K
B
G