Husky H2G3TK - Maintenance Procedures; General Maintenance Tasks

15
-!).4%.!.#%
!VOIDUSINGSOLVENTSWHENCLEANINGPLASTICPARTS-OST
PLASTICSARESUSCEPTIBLETODAMAGEFROMVARIOUSTYPESOF
COMMERCIALSOLVENTSANDMAYBEDAMAGEDBYTHEIRUSE
5SECLEANCLOTHSTOREMOVEDIRTDUSTOILGREASEETC
7!2.).'
$ONOTATANYTIMELETBRAKEFLUIDSGASOLINEPETROLEUM
BASEDPRODUCTSPENETRATINGOILSETCCOMEINCONTACT
WITHPLASTICPARTS#HEMICALSCANDAMAGEWEAKENOR
DESTROYPLASTICWHICHMAYRESULTINSERIOUSPERSONAL
INJURY%LECTRICTOOLSUSEDONFIBERGLASSMATERIALWALL
BOARDSPACKLINGCOMPOUNDSORPLASTERARESUBJECT
TOACCELERATEDWEARANDPOSSIBLEPREMATUREFAILURE
BECAUSETHEFIBERGLASSCHIPSANDGRINDINGSAREHIGHLY
ABRASIVETOBEARINGSBRUSHESCOMMUTATORSETC#ON
SEQUENTLYWEDONOTRECOMMENDEDUSINGTHISTOOLFOR
EXTENDEDWORKONTHESETYPESOFMATERIALS(OWEVERIF
YOUDOWORKWITHANYOFTHESEMATERIALSITISEXTREMELY
IMPORTANTTOCLEANTHETOOLUSINGCOMPRESSEDAIR
,5"2)#!4)/.
!LLOFTHEBEARINGSINTHISTOOLARELUBRICATEDWITHASUFFI
CIENTAMOUNTOFHIGHGRADELUBRICANTFORTHELIFEOFTHEUNIT
UNDERNORMALOPERATINGCONDITIONS4HEREFORENOFURTHER
LUBRICATIONOFTHEBEARINGSISREQUIRED
7!2.).'
7HEN SERVICING USEONLYIDENTICAL(USKY REPLACEMENT
PARTS 5SE OF ANY OTHER PARTS MAY CREATE A HAZARD OR
CAUSEPRODUCTDAMAGE
7!2.).'
!LWAYSWEARSAFETYGOGGLESORSAFETYGLASSESWITHSIDE
SHIELDS DURING POWER TOOL OPERATION OR WHEN BLOWING
DUST)FOPERATIONISDUSTYALSOWEARADUSTMASK
7!2.).'
!LWAYSRELEASEALLPRESSUREDISCONNECTFROMPOWERSUP
PLYANDALLOWUNITTOCOOLTOTHETOUCHBEFORECLEANINGOR
MAKINGREPAIRSONTHEAIRCOMPRESSOR
'%.%2!,-!).4%.!.#%
(UMIDITYINTHEAIRCAUSESCONDENSATETOFORMINTHEAIR
TANK4HISCONDENSATESHOULDBEDRAINEDDAILYANDOR
EVERYHOURUSINGTHEINSTRUCTIONSFOUNDIN$RAININGTHE
4ANK
4HESAFETYVALVEAUTOMATICALLYRELEASESAIRIFTHEAIRRE
CEIVERPRESSUREEXCEEDSTHEPRESETMAXIMUM#HECKTHE
SAFETYVALVEBEFOREEACHUSEFOLLOWINGTHEINSTRUCTIONS
FOUNDIN#HECKINGTHE3AFETY6ALVE
)NSPECTTHETANKYEARLYFORRUSTPINHOLESOROTHERIMPER
FECTIONSTHATCOULDCAUSEITTOBECOMEUNSAFE
WARNING:
Do not at any time let brake fl uids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. Chemical can damage, weaken or
destroy plastic which may result in serious personal
injury. Electric tools used on fi berglass material, wall-
board, spackling compounds, or plaster are subject
to accelerated wear and possible premature failure
because the fi berglass chips and grindings are highly
abrasive to bearings, brushes, commutators, etc.
Consequently, we do not recommend using this tool for
extended work on these type of materials. However, if
you do work with any of these materials, it is extremely
important to clean the tool using compressed air.