4
Jack Operation
1
Inserting the handle
□ Insert the handle (B) into the handle socket of
the jack (A). Ensure the pin on the lower end of
the handle (B) snaps into the socket slot.
A
B
2
Placing the vehicle in park
□ Place the vehicle in PARK and apply the
emergency brake.
3
Closing the jack
□ Close the jack release valve by turning the
handle (B) clockwise.
B
4
Blocking the wheels
□ Block the vehicle wheels that are not being
raised.
5
Centering the jack
□ Center the jack under the load so that the
saddle (1) contacts the load rmly and will
not slip. (Refer to the vehicle manufacturer’s
owner’s manual to locate the approved lifting
points on the vehicle).
1
To Next Page
