Husqvarna 136LiC User Manual (English)

Other manuals for Husqvarna 136LiC

Questions and Answers:

A
Andrea MurphySep 6, 2025
What to do if Husqvarna 136LiC warning sign flashes after start and hangs up?
- R
  Rachel AustinSep 6, 2025
  If a warning sign on the keypad of your Husqvarna Trimmer flashes after you start it and the product hangs up with the green LED on, it could be due to: * A defective signal between the battery and the product. Make sure that the power connectors between the battery and the product are not dirty or damaged. * Loose or damaged small cables between the connector and the control unit. Ensure that these cables are secure and undamaged.
T
Tammy ClarkAug 25, 2025
What to do if Husqvarna Trimmer charger does not start?
- M
  msmithAug 25, 2025
  If the charger for your Husqvarna Trimmer doesn't start and no LEDs come on when the battery is attached, consider the following: * Check for a defective connection between the charger and battery. Ensure the power plugs are clean and undamaged. * The battery may be defective. Check the battery start. * The charger may be defective. Disconnect the charger from the mains outlet for at least 1 minute, then reconnect it. Verify that the fan starts and the green LED illuminates for about 3 seconds. If not, replace the charger.
B
Brandon JacobsAug 27, 2025
What to do if my Husqvarna 136LiC Trimmer will not start?
- A
  Alyssa BrownAug 27, 2025
  If your Husqvarna Trimmer isn't starting, several components could be the cause. Here's what you should check: * Inspect the battery. * Inspect the fuse. * Inspect the cables. * Inspect the safety switch. * Inspect the breaker. * Inspect the electric motor. If the issue continues after checking these, consider changing the control unit.
N
Nicole VasquezAug 27, 2025
What to do if Husqvarna Trimmer keypad lights flash?
- K
  Kimberly WardAug 27, 2025
  If the keypad lights on your Husqvarna Trimmer are flashing, it could be due to: * A defective connection in the keypad connector. Ensure the keypad connector is correctly assembled, dry, undamaged, and free from corrosion. * A short circuit in the keypad. In this case, replace the keypad.
U
urodriguezAug 28, 2025
What to do if Husqvarna 136LiC Trimmer shows red light on keypad?
- D
  Dr. Brenda BrownAug 28, 2025
  If a warning sign on the keypad of your Husqvarna Trimmer shows a red light, it indicates that permanent error codes are preventing the product from running. Erase the error codes using a diagnostic tool. It may also indicate a broken control unit, in which case you should replace it.
B
brianhermanAug 29, 2025
Why Husqvarna 136LiC Trimmer motor speed is changing?
- D
  Daniel TaylorAug 29, 2025
  If the motor speed of your Husqvarna Trimmer is changing, it could be caused by: * A defective connection in the main switch signal connector. Ensure the connector is correctly assembled, dry, undamaged, and free from corrosion. * A damaged or worn main switch. If so, replace the main switch.
C
Christopher HeathSep 10, 2025
Why is the Error LED flashing on my Husqvarna 136LiC?
- J
  Jim BoydSep 10, 2025
  The Error LED might be flashing on your Husqvarna Trimmer due to several reasons: * The battery is discharged: Charge the battery. * Temperature deviation: Use the battery in surroundings where temperatures are between -10 °C and 40 °C. * Over voltage: Check that the mains voltage corresponds with that stated on the rating plate on the machine. * No reason mentioned: Remove the battery from the battery charger.
U
urandallSep 7, 2025
What to do if Husqvarna 136LiC charger shows solid red light when plugged in?
- M
  Miss Brooke Benitez PhDSep 7, 2025
  If the charger for your Husqvarna Trimmer displays a solid red warning sign when plugged into the mains outlet, it indicates a defective charger. Replace the charger.
A
Anthony McdonaldSep 5, 2025
What to do if Husqvarna 136LiC Trimmer warning sign flashes continuously?
- M
  Melissa SmithSep 5, 2025
  If a warning sign on the keypad of your Husqvarna Trimmer flashes continuously, it may be due to: * The temperature being too high. Wait for the product to cool down (max. 5 minutes). * The temperature of the control unit or battery being too low. Ensure that the product and battery are not colder than -10°C.
P
paynestevenSep 2, 2025
What to do if Husqvarna Trimmer warning sign shows constant red light on battery?
- W
  Walter Hammond DVMSep 3, 2025
  If a warning sign shows a constant red light on the battery of your Husqvarna Trimmer when the start button is pressed, it indicates a defective battery. Replace the battery to resolve this issue.