EasyManua.ls Logo

Husqvarna 136LiHD50 - User Manual

Husqvarna 136LiHD50
68 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
EE
EE
nn
nn
gg
gg
ll
ll
ii
ii
ss
ss
hh
hh
((
((
22
22
--
--
22
22
11
11
))
))
ff
ff
rr
rr
ee
ee
nn
nn
cc
cc
hh
hh
((
((
22
22
22
22
--
--
44
44
33
33
))
))
SS
SS
pp
pp
aa
aa
nn
nn
ii
ii
ss
ss
hh
hh
((
((
44
44
44
44
--
--
66
66
66
66
))
))
136 LiHD50
Oper
ator’s manual Manuel d’utilisation
Manual de instrucciones
Please r
ead the operator’s manual carefully and make sure you understand the instructions before using the machine.
Lire attentivement et bien assimiler le manuel d’utilisation avant d’utiliser la machine.
Lea detenidamente el manual de instrucciones y asegúrese de entender su contenido antes de utilizar la máquina.

Table of Contents

Other manuals for Husqvarna 136LiHD50

Questions and Answers

  • P
    Patrick GrahamNov 28, 2025
    What does it mean if a red warning sign flashes on the charger of my Husqvarna 136LiHD50 Trimmer when the battery is attached?
    • S
      Seth NicholsonDec 1, 2025
      A flashing red warning sign on the charger when the battery is attached can indicate several problems: * There may be a defective connection between the charger and the battery. Ensure the power plugs are clean and undamaged. * The battery temperature could be too high. Allow the battery to cool in the charger for 1-5 minutes. * The ambient temperature might be too low. Ensure the ambient temperature is above 5°C. * The battery temperature may be too low. Ensure the battery temperature is above 5°C. * The battery could be defective. Check the battery by pressing the start button; at least one green LED should illuminate. If not, replace the battery. * The charger itself might be defective. Disconnect the charger from the mains outlet for at least 1 minute, then reconnect it. V...
  • A
    Anthony WrightAug 25, 2025
    Why is the Error LED flashing on my Husqvarna Trimmer's battery and/or battery charger?
    • N
      Natalie FritzAug 25, 2025
      The Error LED might be flashing on the battery or battery charger due to a temperature deviation. Use the battery in surroundings where temperatures are between -10 °C and 40 °C. It can also happen because of over voltage: check that the mains voltage corresponds with that stated on the rating plate on the machine. If not, remove the battery from the battery charger.
  • M
    Meredith RiversAug 26, 2025
    What does it mean when the green activate LED is flashing on my Husqvarna 136LiHD50 Trimmer?
    • V
      Victor Cook DDSAug 26, 2025
      A flashing green activate LED indicates low battery voltage. Charge the battery.
  • D
    destinybrownAug 27, 2025
    What to do if a warning sign flashes red on the battery of my Husqvarna 136LiHD50 when the start button is pressed?
    • K
      Kimberly RubioAug 27, 2025
      If a warning sign flashes red on the battery when you press the start button, it could indicate several issues: * The battery temperature might be too high. Allow the battery to cool down (or insert it in the charger to expedite cooling). * The battery voltage might be too low. Try charging the battery. * The battery temperature could be too low. Ensure the battery temperature is above -10° C. * The battery itself may be defective and need replacement.
  • E
    eileenadamsAug 30, 2025
    Why is there a solid red warning sign on the charger of my Husqvarna 136LiHD50 when I plug it into the mains outlet?
    • A
      Amanda BrownAug 30, 2025
      A solid red warning sign on the charger when plugged into the mains outlet indicates a defective charger. Replace the charger.
  • M
    Mr. Jason OconnorNov 21, 2025
    Why does the Husqvarna 136LiHD50 Trimmer not start and no LEDs light up?
    • C
      Cory JenkinsNov 21, 2025
      If your Husqvarna Trimmer doesn't start and no LEDs illuminate when you press the power button, there could be several reasons: * The battery may be defective. Press the on/off button to check the battery; at least one green LED should light up. * The plug between the battery and the product could be defective. Ensure the power connectors are clean and undamaged. * There may be a defective connection in the keypad connector. Check that it's correctly assembled, dry, undamaged, and free of corrosion. * The keypad might be broken, requiring replacement. * The cables between the control unit and keypad/main switch might be damaged; repair or replace them if visible damage is present. * A short circuit in the control unit could be the cause, necessitating replacement of the contro...
  • J
    Jamie CampbellSep 18, 2025
    What does it mean if a warning sign shows a constant red light on the battery of my Husqvarna 136LiHD50 when the start button is pressed?
    • B
      Beth PittsSep 18, 2025
      A constant red light on the battery warning sign when the start button is pressed indicates a defective battery. Replace the battery.
  • A
    Amber WadeSep 22, 2025
    Why does the charger of my Husqvarna Trimmer not start and no LEDs come on when the battery is attached?
    • T
      Timothy MorganSep 22, 2025
      If the charger doesn't start and no LEDs illuminate when the battery is attached, it could be due to: * A defective connection between the charger and the battery. Ensure the power plugs are clean and undamaged. * A defective battery. Check the battery start. * A defective charger. Disconnect the charger from the mains outlet for at least 1 minute, then reconnect it. Make sure the fan starts and the green LED comes on for approximately 3 seconds. If not, replace the charger.
  • A
    Andrew VanceSep 9, 2025
    Why does my Husqvarna 136LiHD50 Trimmer work but there is no indication light on the keypad?
    • J
      John HamiltonSep 9, 2025
      If your Husqvarna Trimmer works but the keypad light doesn't illuminate, it could stem from: * A defective connection in the keypad connector. Check the keypad function using a battery diagnostic tool and ensure the keypad connector is correctly assembled, dry, undamaged, and free of corrosion. * A broken keypad, which would necessitate replacement.
  • S
    Scott KellySep 6, 2025
    What should I do if a warning sign on the keypad of my Husqvarna 136LiHD50 Trimmer flashes after start and the product then stops?
    • R
      Robert NguyenSep 6, 2025
      If a warning sign flashes on the keypad after starting the product and then the product stops, consider the following: * The power trigger may have been pushed during start. Avoid pushing the power trigger when starting the product. * There may be water in the main switch signal connector. Disassemble and dry the stop signal connector, then reassemble it. * There could be a short circuit in the keypad. Replace the keypad. * There might be a short circuit in the main switch. Replace the main switch.

Husqvarna 136LiHD50 Specifications

General IconGeneral
BrandHusqvarna
Model136LiHD50
CategoryTrimmer
LanguageEnglish

Related product manuals