What does it mean when a warning sign on the keypad of my Husqvarna 136LiHD50 shows a red light?
A red light on the keypad warning sign indicates: * Permanent error codes are preventing the product from running. Erase the error codes using a diagnostic tool. * A broken control unit. Replace the control unit.
Why is the Error LED flashing on my Husqvarna Trimmer's battery and/or battery charger?
The Error LED might be flashing on the battery or battery charger due to a temperature deviation. Use the battery in surroundings where temperatures are between -10 °C and 40 °C. It can also happen because of over voltage: check that the mains voltage corresponds with that stated on the rating plate on the machine. If not, remove the battery from the battery charger.
What does it mean when the green activate LED is flashing on my Husqvarna 136LiHD50 Trimmer?
A flashing green activate LED indicates low battery voltage. Charge the battery.
What to do if a warning sign flashes red on the battery of my Husqvarna 136LiHD50 when the start button is pressed?
If a warning sign flashes red on the battery when you press the start button, it could indicate several issues: * The battery temperature might be too high. Allow the battery to cool down (or insert it in the charger to expedite cooling). * The battery voltage might be too low. Try charging the battery. * The battery temperature could be too low. Ensure the battery temperature is above -10° C. * The battery itself may be defective and need replacement.
Why is there a solid red warning sign on the charger of my Husqvarna 136LiHD50 when I plug it into the mains outlet?
A solid red warning sign on the charger when plugged into the mains outlet indicates a defective charger. Replace the charger.
Why does the keypad on my Husqvarna 136LiHD50 Trimmer flash?
If the keypad lights on your Husqvarna Trimmer are flashing, it could be due to: * A defective connection in the keypad connector. Ensure the keypad connector is correctly assembled, dry, undamaged, and free of corrosion. * A short circuit in the keypad. If this is the case, the keypad needs to be replaced.
Why don't LEDs flash on the battery of my Husqvarna 136LiHD50 Trimmer when I press the start button?
If no LEDs flash on the battery when you press the start button, the battery is likely defective and needs to be replaced.
Why does my Husqvarna 136LiHD50 start immediately when the battery is added without pressing the keypad?
If the product starts immediately when the battery is added, without pressing the keypad, it indicates a short circuit in the keypad. Replace the keypad.
Why does my Husqvarna 136LiHD50 Trimmer work but there is no indication light on the keypad?
If your Husqvarna Trimmer works but the keypad light doesn't illuminate, it could stem from: * A defective connection in the keypad connector. Check the keypad function using a battery diagnostic tool and ensure the keypad connector is correctly assembled, dry, undamaged, and free of corrosion. * A broken keypad, which would necessitate replacement.
What should I do if a warning sign on the keypad of my Husqvarna 136LiHD50 Trimmer flashes after start and the product then stops?
If a warning sign flashes on the keypad after starting the product and then the product stops, consider the following: * The power trigger may have been pushed during start. Avoid pushing the power trigger when starting the product. * There may be water in the main switch signal connector. Disassemble and dry the stop signal connector, then reassemble it. * There could be a short circuit in the keypad. Replace the keypad. * There might be a short circuit in the main switch. Replace the main switch.
To Next Page
General
